- Last Active
Kathy, I forgot to add the image of the P-Piece Plot where it shows Label 'S' to use a pen. Yes I plot all pieces like this as I use same method for markers but send as GEN files for the cutter. Its much easier for me to do this and have Markers s…
I export the pieces following this process: Accumark Explorer, Right click on piece, Send to plotter, Process. I have set the Piece Plot options to Use Specified Extensions - DXF I then find the piece where I processed it to and open in Cutworks.…
I found a Link from Accumark that loads this Forum. Its a great place to find issues and resolve small issues you have without having to call Gerber and registering an issue, then having to wait for the reply. The response and information is much q…
Kathy, Been using Accumark since 1990 and over the years had many training sessions. I already have LableS = LT2 set in my Annotation table but when opening in AutoCAD via DXF Plot export my seams shows as a solid line? As for the Piece annotatio…
Kathy, yes its stopped now, I think it was the settings in PDS when I checked the default Rule table. Thank you
I ran the Check One Storage Area in AM_Explorer. I'm using V9 Storage areas. I checked PDS preferences for the rule table. Followed your guidance and no error message. Thank you.
Thank you ladies, I think I know what's happened. My area where I want Digitised data to be saved is on a Network Drive. That morning I must have connected to Accumark just prior to it doing its morning scan and therefore did not see the Area I have…