Post your Gerber Technology product questions here on our forum! Start by selecting the category you need help with on the right hand side of the page; then, create your new post. One of our team members (or another forum member) will jump in and help.

Accuplot 320 error 2

tomfoltertomfolter Posts: 2
I have Accuplot 320 and after hitting enter to initialize plotter the screens shows enabling servo power then error 2: drive status fault detected
Any suggestions? 


  • Jost LindemannJost Lindemann Posts: 71 Gerber Staff 💛
    This error indicates probably a problem in EStop-Loop. Is a limit switch made? Push Carriage into the middle of the beam, push beam appr. 30 cm away from operator panel to ensure no switch is made.
    Cabling problem inside whip or intermediate ribbon cable? Check Estop loop by looking into the schematics. Mechanical problem with limit-switches ?

  • tomfoltertomfolter Posts: 2
    The carriage seems to be in the middle. 
    Not sure how to look into schematics? I’ll check cables but they all looked in good condition.
Sign In or Register to comment.