Gerber Training for IT Department

tidivi23tidivi23 Posts: 143 ✭✭
in General
Hi :-) 

Is there any basic Gerber training available for IT departments? Some sort of training that will touch on the basics of how everything is and should be set up in each drive and/or how to troubleshoot certain issues. 

My IT department could really benefit from something like that.  
· Share on FacebookShare on Twitter

Comments

  • Sue CarrierSue Carrier Posts: 108 Gerber Staff 💛
    You can start by looking at the Training Docs \ AccuMark IT Manual folder for documents about various areas in the AccuMark. 

    The Release Notes will give you information about the system software and hardware requirements, etc. That document can be found in the Documentation folder. 

    All these docs are available through the Gerber G icon on the desktop - this is installed with the AccuMark software.

    I have also sent your request onto our Training supervisor.  Check out GerberU for classes.
    · Share on FacebookShare on Twitter
  • tidivi23tidivi23 Posts: 143 ✭✭
    Hi @ Sue Carrier

    Thank you :-) 
    · Share on FacebookShare on Twitter
  • tidivi23tidivi23 Posts: 143 ✭✭
    @ Sue Carrier 

    I actually do not have the "G" icon on my desktop. Where else can I find those documents?

    I am using version 10.3. Not sure if that matters.
    · Share on FacebookShare on Twitter
  • Sue CarrierSue Carrier Posts: 108 Gerber Staff 💛
    what version of software are you using?   then I can guide you

    · Share on FacebookShare on Twitter
  • MuhammadOwaisMuhammadOwais Posts: 348 ✭✭✭
    @tidivi23 There must be a folder on Your desktop named AccuMark vX.X (X.X is for version). It have an Icon of G of Gerber...
    Otherwise check out
    C:\ProgramData\Gerber Technology\Training Docs
    Or
    C:\ProgramData (x86)\Gerber Technology\Training Docs


    Regards...
    I'm a Cutting CAD Room Specialist and Technology Enthusiast...
    · Share on FacebookShare on Twitter
Sign In or Register to comment.