Post your Gerber Technology product questions here on our forum! Start by selecting the category you need help with on the right hand side of the page; then, create your new post. One of our team members (or another forum member) will jump in and help.

Gerber Training for IT Department

tidivi23tidivi23 Posts: 148 ✭✭
Hi :-) 

Is there any basic Gerber training available for IT departments? Some sort of training that will touch on the basics of how everything is and should be set up in each drive and/or how to troubleshoot certain issues. 

My IT department could really benefit from something like that.  


  • Sue CarrierSue Carrier Posts: 115 Gerber Staff 💛
    You can start by looking at the Training Docs \ AccuMark IT Manual folder for documents about various areas in the AccuMark. 

    The Release Notes will give you information about the system software and hardware requirements, etc. That document can be found in the Documentation folder. 

    All these docs are available through the Gerber G icon on the desktop - this is installed with the AccuMark software.

    I have also sent your request onto our Training supervisor.  Check out GerberU for classes.
  • tidivi23tidivi23 Posts: 148 ✭✭
    Hi @ Sue Carrier

    Thank you :-) 
  • tidivi23tidivi23 Posts: 148 ✭✭
    @ Sue Carrier 

    I actually do not have the "G" icon on my desktop. Where else can I find those documents?

    I am using version 10.3. Not sure if that matters.
  • Sue CarrierSue Carrier Posts: 115 Gerber Staff 💛
    what version of software are you using?   then I can guide you

  • MuhammadOwaisMuhammadOwais Posts: 360 ✭✭✭
    @tidivi23 There must be a folder on Your desktop named AccuMark vX.X (X.X is for version). It have an Icon of G of Gerber...
    Otherwise check out
    C:\ProgramData\Gerber Technology\Training Docs
    C:\ProgramData (x86)\Gerber Technology\Training Docs

    I'm a Cutting CAD Room Specialist and Technology Enthusiast...
Sign In or Register to comment.