GTCO digitzer

Our fashion department has been upgraded to V10. We have been gifted at 48" GTCO rollup digitizer. Is there any way we can get it to interface with the Gerber Accumark software.
Thank You.
Judy

Comments

  • Kathy ValadeKathy Valade Gerber Staff 💛
    We support the GTCO rollup 3036. Do you have this model?
  • We have the GTCO rollup III, the only one GTCO does. Ours is 3648 which is the size of the digitizer. It as a 36x48 inch. the 3036 is a 30x36 in. Should it make any difference on the size. They all use the same Tablet works software but we were given only 2 options in hardware config for digitizer, Accumark and Inverstronica and when the GTCO was plugged in it did not recognize it.
     Is there something else we need to do in hardware config.
  • Kathy ValadeKathy Valade Gerber Staff 💛
    edited November 5
    The GTCO 3036 is the only model that we support. It requires that you install a special driver and purchase the Gerber input menu from Gerber and a proprietary serial cable from Calcomp.  

Sign In or Register to comment.