Post your Gerber Technology product questions here on our forum! Start by selecting the category you need help with on the right hand side of the page; then, create your new post. One of our team members (or another forum member) will jump in and help.
Single Ply DCS 1500 Laser Origin question
PacificOrthotic
Posts: 1 ✭
My machine is setup such that to start a job in CutWorks, I position my laser to the lower left corner of the material and then begin. The machine then cuts to the Right of that point.
I'm wondering if it is possible to setup a Cutworks file or enable a job setting that would reverse this: meaning that I would set the laser to the lower Right corner of the material and the machine would cut to the Left of that point.
Is this possible?
I'm wondering if it is possible to setup a Cutworks file or enable a job setting that would reverse this: meaning that I would set the laser to the lower Right corner of the material and the machine would cut to the Left of that point.
Is this possible?
Tagged: