Post your Gerber Technology product questions here on our forum! Start by selecting the category you need help with on the right hand side of the page; then, create your new post. One of our team members (or another forum member) will jump in and help.
Moving Origin
fabriceallaz
Posts: 3 ✭
in General
Hi,
DCS 2500-CutWorks
Is it possible to have 2 origin(s) with the machine and decide which origin we would like to use before cutting (of course..)
I have one origin close to the computer(good) but sometime i would like an origin in the opposite X side so i have room to re-roll long material as i do not have a "rolling" carpet.
Thanks, Fabric
DCS 2500-CutWorks
Is it possible to have 2 origin(s) with the machine and decide which origin we would like to use before cutting (of course..)
I have one origin close to the computer(good) but sometime i would like an origin in the opposite X side so i have room to re-roll long material as i do not have a "rolling" carpet.
Thanks, Fabric
Answers
It seems that Lectra/Gerber keeps everything under tight control and we cannot find much info online, concerning the software or our machine the DCS 2500.