Control direction of one piece in the marker/model

LucyD

Hi, I want to control the direction in the marker of just one piece of the model, I tried in the Laylimits to put W for that piece's model category label, but still it comes out 2way.
The rest of the pieces can be  2 way.
Thank you!

Sandro Palumbo

Hi had you set also the next record that specify the value of rotation ?

Vasyl

To fix piece you have set SW - deny flip as well rotation.
You can set option to match way of pair.

LucyD

I want pair but no rotation on the specific piece, and I want option to rotate everything else in the model? 

Vasyl

Then 1st raw DEFAULT - for all pieces.
2nd - category of wanted piece...

LucyD

Is this correct - see pic?

Vasyl

LucyD сказав:

Is this correct - see pic?

FRILL       SW

LucyD

Sorry, no it still comes out two-way - what am I doing wrong?
I have the Piece Category labelled as FRILL in the model
I have the piece category FRILL in the Lay-limits, PIECE OPTIONS  I tried W and WS and P, Flip Code 1, but it always comes out frill 2-way on the marker.

Vasyl

Do you have two symetric pieces? Like left/right front?

Show printsreen 

LucyD

Hi Vasyl, thank you for your help. Please see the model info and the marker - the crosses mark the pieces that should not be rotated.

LucyD

Yes, they are left and right, but I want to rotate all other pieces in the marker but not those two pieces.

Vasyl

LucyD сказав:

Yes, they are left and right, but I want to rotate all other pieces in the marker but not those two pieces.

So...
S - deny rotation, W -: deny flip....

Do you nest by accunest or manually?

LucyD

I make the marker using easyorder then use accunest to get better fabric use

LucyD

The menu in Laylimits says that S = allow 108 rotation. I don't want my frill to rotate but I do want it to flip so I have a pair.

Vasyl

LucyD сказав:

I make the marker using easyorder then use accunest to get better fabric use

Then you've check options of nesting. Is nesting matters of laylimits. Or there set own parameters rotation...

MuhammadOwais

@LucyD Have You tried using Y or XY flips instead of -- and X...!!!


Put a value in Y instead of X to make a pair on Y axis and keep Rotation and Flip off in the Lay Limit... 

LucyD

I finally worked it out - it works when I made Lay Limits as image below- the bundling change makes the difference - it was not correct before.
Thanks everyone for all your ideas and help.